tspdk Posted November 3, 2010 Report Share Posted November 3, 2010 (edited) Hi Does any one have a illustration of how to make the b-serie bridle ? I need a drawing or something so i can see how all knots are made ! Also need to fik my wife bridle on her new EXP, because it was felt apart when it arrived from the dealer Hope any one out there can help me ! Regards Thomas www.4liners.dk Edited November 3, 2010 by Thomas S. Petersen Quote Link to comment Share on other sites More sharing options...
0 beach Posted November 3, 2010 Report Share Posted November 3, 2010 The best I can do is say call the factory and me or Lolly will run you thru the exp bridle as for the B series why do you need the illustration, if I had one Id send it, but I don't but we do sell replacements.... Ben Quote Link to comment Share on other sites More sharing options...
0 awindofchange Posted November 3, 2010 Report Share Posted November 3, 2010 The B-Series bridle is the same bridle used on the 1.5 SLE. There is no difference. What came apart on your EXP bridle? We have had some new kites that the loop has came off on the end caps while it was packaged up. If this happens it is very simple to fix. All you need to do is to slip the loop of the bridle back through the end cap where the bungee cord goes and then flip the loop up over the end cap so that it is secure. Check any of the other end caps to see how it is done if you need a reference. The only other place that the bridle can come apart is at the attachment point where you connect your lines. If this has come apart then do the following to get it back together: Step 1: Lay the bridles out so that the horizontal bridle (that runs from end to end) is up above the vertical bridle (that runs from the top of the kite to the bottom). Step 2: Take the long loop of the horizontal bridle (where you attach your flying lines to) and hold it above the small vertical bridle loop (on the top side of the vertical bridle). Step 3: Feed the short vertical bridle loop through the middle of the long loop of the horizontal bridle. Step 4: Then bend the long loop of the horizontal bridle and feed it through the top side of the short loop that you just fed through in the previous step. Pull tight and your done. If you do need a new bridle they are very inexpensive to buy and are already pre-measured and tied. Replacement bridles can be purchased from us or any authorized Revolution dealer. Hope that helps. Quote Link to comment Share on other sites More sharing options...
0 tspdk Posted November 3, 2010 Author Report Share Posted November 3, 2010 @Ben I order a new for my B-serie ! I assume that all the bridles for the STD, Mid VTD and VTD is the same ?! I only needed a ill. to see how it was made (knots lenght ect.) @awindofchange Thank you.. This was what I needed to I can fix it. !! Quote Link to comment Share on other sites More sharing options...
Question
tspdk
Hi
Does any one have a illustration of how to make the b-serie bridle ?
I need a drawing or something so i can see how all knots are made !
Also need to fik my wife bridle on her new EXP, because it was felt apart when it arrived from the dealer
Hope any one out there can help me !
Regards
Thomas
www.4liners.dk
Edited by Thomas S. PetersenLink to comment
Share on other sites
3 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.